Digital Petrol Turbine Fuel Meter Totaliser

Description

Reliable, lightweight, accurate, digital fuel meter which is compatible with petrol. With its rugged aluminium housing and sealed electronic circuitry. Flows up to 100LPM. Ideal for use on any fuel transfer pump, particularly on farms, fuel depots with at least 10-100 LPM flow range. The BSP female 1" threaded inlet/outlets make plumbing simple and Scintex can supply fittings and hose to suit your needs.

Lightweight Digital Turbine Fuel Meter

• Compatible with Petrol and with alcohol blends up to 15%
• Rugged aluminium housing
• 1" BSP Female Inlet/1" BSP Female Outlet
• With rings built in 316 stainless steel
• The display is calibrated for petrol, diesel fuel or kerosene
• With an operating temperature of -10° C to +54° C
• 300 PSI Pressure Rating
• Flow Rating of up to 100 LPM
• An accuracy reading of ±5%

A Better Digital Flow Control

Achieve better flow control during your fuel transferring. Used to measure the quantity of fluid that has been moved during the transfer process. With a visual display, this meter can be used by residential, commercial and industrial buildings that consume fuel gas supplied by a gas utility, or a diesel refuelling system.

This meter displays a totalised flow. Flow rate is not displayed.

Use of Meter provides the owners with the following but not limited to:

• Actual fuel consumption records
• Time tracking of the machinery work
• Fuel rationing
• Fuel theft detection and prevention
• Real-time monitoring and fuel consumption optimisation
• Engine tests for fuel consumption

Turbine Fuel Meter Maintenance

This meter is virtually maintenance-free. However, it is important that the rotor moves freely. Keep the meter clean and free of contaminants. If the rotor does not turn freely, apply a penetrating lubricant on the rotor, shaft and bearings. Remove any debris or deposits from the rotor using a soft brush or a small probe. Be careful not to damage the turbine rotor or supports.

NOT SUITABLE FOR WATER OR CHEMICALS

Activate the Meter

Turn ON by starting fuel flow or briefly pressing the DISPLAY button. The meter will display the batch or cumulative total from last use. The meter is programmed to conserve power by automatically turning off if not used for about one minute.

Reset Batch Total

Press DISPLAY briefly to display the batch total. Hold the DISPLAY button for three seconds to reset the batch total to zero.

Battery Replacement:

The meter is powered by two AAA alkaline batteries, which may be replaced while the meter is installed. When batteries are removed or lose power, the batch and cumulative totals reset to zero but the factory calibration is retained.